|
|
airmachines.com self-feed units: selection guide

Self Feed Units: The Selection
Process
1. Select Base Unit:
a) Pneumatic or Electric
b) Correct rpm
|
Metric |
R = |
318.5 x Surface Meters per Minute
Drill dia. (mm) |
|
US Standard |
R = |
3.82 x Surface Feet per Minute
Drill dia. (inches) |
2. Select Front End Attachment:
|
a) |
Chuck |
Base drill comes standard with 3/8" (10 mm) drill chuck.
|
|
b) |
Collet Holder & Collet |
For Tappers, the tapping head is included (single spindle only).
|
|
c) |
Multiple Spindle Head |
Multiple spindle head collets need to be ordered separately.
|
|
d) |
Offset Head |
For drilling applications requiring special clearances.
|
|
e) |
Spindle Positioners |
To facilitate rapid changeover of spindle positioning where alternative
settings are required on Multi-Spindle heads.
|
3. Select Mounting Bracket:
|
a) |
Nose Angle Bracket |
|
b) |
Nose Flange |
|
c) |
Column and Clamp Options |
4. Select Control Options:
|
a) |
Return Limit Kit |
Sends out a positive signal at the retract end of the self feed cycle.
|
|
b) |
Dwell Control |
Used to dwell for a set period of time in the extended position.
|
|
c) |
Hydraulic Feed Control |
Sets a constant feed rate through the material.
|
|
d) |
Peck Feed Kit |
Allows pecking of unit for drilling deep holes.
|
|
e) |
Swarf Exclusion Kit |
Protects drill unit from swarf (chips, dirt, etc.).
|
|
f) |
Exhaust Collector |
Reduces noise and protects drill unit from swarf. Allows muffling or
piping of exhausted air away from the work area.
|
|
g) |
Bottom Limit Kit |
Sends a signal when drill unit is fully extended.
|
|
h) |
PLC Interface Module |
Permits PLC to communicate with Self Feed Units.
|
|
i) |
Skipcheck Unit |
Enables drill units to economically transit tubular sections.
|
We also supply / replace / repair what were formerly CompAir tools. If
you're looking to buy new or repair /
replace your existing CompAir, Broomatic or BroomWade tools, don't
hesitate to browse this Website, or call, fax
or E-mail our company.
Phone: 330.759.1620 E-mail: info@airmachines.com
Fax: 330.759.9906
All programs and pricing subject to change without notice.
AirMachines.com is a manufacturer of air motors and self-feed drill
units.
AirMachines.com is an authorized repair center for what were formerly
CompAir tools.
|
|